-
-
-
HOW TO USE Spray the product on the cloth and wipe on the surface to be cleaned. In the case of stubborn dirt, spray directly onto the surface. Rinse in case of product residual. -
DILUTION From 2 (15 liters) to 3 (25 liters) tablets depending on the size of the fryer. HOW TO USE Drain the used oil. Fill the fryer with clean water by adding:- n. 2 tablets for 15 liter friers
- n. 3 tablets for 25 liter friers
-
HOW TO USE Spray the product over the surface to remove the stain from and wipe until completely dry. For small surfaces and daily dirt, spray the product onto the cloth. -
HOW TO USE Spray the product from a distance of 20-25 cm on the surface and wipe until completely dry. No rinse needed. In case of stubborn greasy dirt, clean the surface beforehand with a degreaser. In case of limescale is present, first clean the surface with a descaler. -
Ready to use HOW TO USE- Press the top of the cap and unscrew it to open the bottle.
- To clear clogged drains: pour 500 ml (half of the contents) into the clogged drain, even in the presence of stagnant water. Leave to act for at least 5 minutes.
- For stubborn blocks leave for 12 hours and then run hot water.
- For weekly maintenance: pour 250ml (1/4 bottle) to keep drains free and prevent blocks and bad smells.
- Do not use the plunger suction cu
-
Dilution 1% (100 ml in 10L). The suggested dilution allows to economize and reduces the environmental impact to the minimum. A small amount of product is enough compared to a diluted product. In case of persistent dirt, try higher dilution rates. How to use Dilute the product in water at the indicated dilution. Spread the solution on the surface; leave to act and let dry. In case of persistent dirt, repeat the operation and rinse. -
Features
Wax that protects conductive floors in areas where the dispersal of static electricity is essential to safety. Does not isolate the floor (cert. 25246, Italian Galileo Ferraris National Electrotechnical Institute, Turin).
Dilution
Ready to use.
FeaturesProduct yields (m2/lt):
Volume (lt) of pure product diluted according to suggested dilutions.Operation category Conc.% Product yield (m2/lt) Notes FLOOR WAXING 100% 20 2 coats How to use
After carefully removing wax using a wax stripper from the SUTTER PROFESSIONAL range, rinse and apply two coats of wax using the special wax applicator. Leave to dry approximately 45 min. between one coat and the next. Also suitable for maintenance with UHS spray (single disc machine at very high speed with cream disc) by diluting Elettra 1:3 with water.
-
Features
Degreasing detergent for all surfaces. Excellent for removing fatty residue also in the food area (HACCP). Also ideal for being used on stainless steel surfaces.
Dilution
1 ECOCAPS in one 500 ml bottle of water.
-
Features
Multi-purpose detergent for all modern surfaces, mirrors, windows and doors.
Dilution
1 ECOCAPS in one 500 ml bottle of water (preferably warm). The suggested dilution allows to economize and reduces the environmental impact to the minimum. A small amount of product is enough compared to a diluted product.
How to use
Put an ECOCAPS directly into the bottle and add water. When the capsule has dissolved, clean the surfaces. Spray the product onto the cloth. If the case of excessive dirt, spray onto the surface and rinse.
-
Features
Specific alkaline detergent for removing burnt fat from ovens, grills, hot plates and roasting spits. Suitable for use in the food area (HACCP).
Dilution
Ready to use
How to use
Heat the surfaces to be cleaned at 60°-70°C. Turn off and afterwards spray the product evenly. Leave to act for a few minutes, rub with abrasive tool and rinse with sponge cloth and water. Before use the oven heat for 10 minutes.
