-
HOW TO USE Spray the product on the cloth and wipe on the surface to be cleaned. In the case of stubborn dirt, spray directly onto the surface. Rinse in case of product residual. -
HOW TO USE Spray the product over the surface to remove the stain from and wipe until completely dry. For small surfaces and daily dirt, spray the product onto the cloth. -
HOW TO USE Spray the product from a distance of 20-25 cm on the surface and wipe until completely dry. No rinse needed. In case of stubborn greasy dirt, clean the surface beforehand with a degreaser. In case of limescale is present, first clean the surface with a descaler. -
Dilution 1% (100 ml in 10L). The suggested dilution allows to economize and reduces the environmental impact to the minimum. A small amount of product is enough compared to a diluted product. In case of persistent dirt, try higher dilution rates. How to use Dilute the product in water at the indicated dilution. Spread the solution on the surface; leave to act and let dry. In case of persistent dirt, repeat the operation and rinse. -
Features
Natural and aliphatic solvent-based degreasing microemulsion with high solubilising power.
Dilution
MECHANICAL CLEANING: 2% - 5% (200 ml to 500 ml in 10 L of water); MANUAL CLEANING: 5% - 15% (500 ml to 1,5 L in 10 L of water).
How to use
Dilute the product in a bucket for MANUAL cleaning or with SCRUBBING MACHINES/SINGLE DISC MACHINE. Apply to surface; leave to act, rub to remove stubborn dirt and then rinse. Suitable for stains like rubber, tar, glue, etc. Also suitable for dry wax stripping.
-
Features
Buffered super-active acid detergent for the removal of scale, cement, white lead residues, salt efflorescence and rust from acid-resistant surfaces. Excellent also for cleaning cement mixers. Also ideal for final cleaning of the construction site for the removal of whitewash and plaster.
Dilution
5% - 20% (0,5 L - 2 L every 10 L of water).
Packaging
-
Features
Acid cleaner specifically formulated to remove limescale deposits from surfaces. Suitable for first treatment of terracotta, concrete or stone floors.
Dilution
10% - 20% (1 L - 2 L every 10 L of water).
-
Features
Wax that protects conductive floors in areas where the dispersal of static electricity is essential to safety. Does not isolate the floor (cert. 25246, Italian Galileo Ferraris National Electrotechnical Institute, Turin).
Dilution
Ready to use.
FeaturesProduct yields (m2/lt):
Volume (lt) of pure product diluted according to suggested dilutions.Operation category Conc.% Product yield (m2/lt) Notes FLOOR WAXING 100% 20 2 coats How to use
After carefully removing wax using a wax stripper from the SUTTER PROFESSIONAL range, rinse and apply two coats of wax using the special wax applicator. Leave to dry approximately 45 min. between one coat and the next. Also suitable for maintenance with UHS spray (single disc machine at very high speed with cream disc) by diluting Elettra 1:3 with water.
-
Features
Degreasing detergent for all surfaces. Excellent for removing fatty residue also in the food area (HACCP). Also ideal for being used on stainless steel surfaces.
Dilution
1 ECOCAPS in one 500 ml bottle of water.
-
Features
Acid descaling cleaner specifically for removing limescale deposits from enamelled surfaces, taps, stoneware and ceramics. In compliance with the following EN Tests standard*: 1276 (Sol. 4%).
Dilution
3% - 5 % (300 ml to 500 ml in 10 L of water) For stubborn deposits on hard surfaces (stoneware, ceramics, concrete) dilute to 10% (1 L every 10 L of water).
How to use
Dilute the product in water to the recommended concentration. Clean the surfaces. Rinse thoroughly.
-
Features
Highly concentrated disinfectant* detergent colourless and fragrance-free, based on fifth generation quaternary ammonium salts, for the daily cleaning and disinfection of all washable surfaces. For general surfaces, including in the food area and in the medical area. Also suitable for the cleaning and disinfecting* surfaces that can come into contact with food (HACCP). Ideal for removing organic dirt from all surfaces (even floors). RATIO System.
It is particularly suitable for disinfecting environments where there is the risk of contamination, and however in all environments used by the public (hospitals, schools, hotels, offices, locker rooms, bathrooms). COMPOSITION: 100 g of product contains: Didecyldimethylammonium Chloride (DDAC (C8-10)) (CAS n. 68424-95-3) 6,55g; Alkyl (C12-16) dimethylbenzylammonium chloride (ADBAC/BKC (C12-16)) (CAS n. 68424-85-1) 4,37g; Co-formulants and water up to 100g. In compliance with the following EN Tests standards*: 1276, 1650, 13697, 14476, 16777.Dilution
ONLY USE DILUTED! Product diluted/dosed by the RATIO dosing system. For further information please contact the Sutter Professional technician.
-
Features
Fast-acting detergent, highly effective for ink and marker pen stains and for greasy stains. Guarantees an instant and effective cleaning action on the most stubborn stains. Leaves surfaces clean and free of traces. Eliminates the most stubborn stains such as indelible felt-tip pens, ink, etc. from hard surfaces. Ideal for all periodic and comprehensive cleaning where no rinsing is required. Floral scent, allergen-free (Reg. 648/2004), delicate and long-lasting fragrance. It contains vegetal origin raw materials (e.g. surfactants, soap) coming from the processing of coconut oil. Phosphate free. APPLICATIONS: removal of heel marks from untreated floors, removal of insects from the glass, removal of adhesives and glues from glass, floors, washable surfaces and unpainted aluminium, dry wax stripping of floors (except rubber or linoleum).
Dilution
Ready to use. Also suitable for the cleaning of internal surfaces within boats, ships and other transport. The suggested dilution allows to economize and reduces the environmental impact to the minimum. This product is not intended for large-scale cleaning.
How to use
750 ml size: spray the product over the surface to remove the stain from and wipe until completely dry. 5 kg size: pour the product into the sprayer before use. Spray the product over the surface to remove the stain from and wipe until completely dry. For small surfaces and daily dirt, spray the product onto the cloth. Spot test on an inconspicuous part of material (fabrics, leather, etc...) before use to make sure it is compatible. Check colourfastness on painted surfaces. Do not use on ABS plastic (e.g. special telephone covers), keyboards, LCD screens. Do not spray the product directly onto electrical appliance components. Do not use on coated floors and surfaces.
